Grizzly EXTREME G0605X, Owner'S Manual

Page: 29 / 76

G0605X/G0606X Extreme Series 12" Table Saw
-27-
4. Remove all tools and foreign objects from
the machine.
5.
Connect the tablesaw to the power source.
6.
Put on safety glasses and hearing protec-
tion, and make sure any bystanders are
wearing safety glasses, hearing protection,
and are out of the way.
7. Make sure the safety pin is not installed.
8. Keep a finger on the STOP paddle ( Figure
31 ) at all times during the test run.
9. Press the ON button.
—If any problems occur, immediately press
the STOP paddle and DISCONNECT THE
SAW FROM THE POWER SOURCE.
Turn to
Troubleshooting
on
Page 45
and
correct the problem before operating the
machine further.
—If you cannot easily locate the source of
an unusual noise or vibration by yourself,
please contact Technical Support at (570)
546-9663.
—If the saw is operating normally, press the
STOP paddle
.
This should stop the saw.
10.
Lift the paddle switch and insert the safety pin
through the ON button.
11. Press the ON button.
— If the saw starts, immediately press the
OFF button and DISCONNECT THE SAW
FROM THE POWER SOURCE. The safety
disabling feature is not working correctly.
Please contact our Technical Support at
(570) 546-9663 immediately.
— If the saw does not start, the safety dis-
abling feature is working correctly.