-28-
G0605X/G0606X Extreme Series 12" Table Saw
Operation Safety
SECTION 4: OPERATIONS
Basic Controls
The basic controls for the table saw are shown in
Figure 36
. Setting up for a typical operation con-
sists of the following three steps:
1.
Make sure the blade tilt is correct. If it needs
to be adjusted, loosen the blade tilt lock,
turn the blade tilt handwheel, and tighten the
lock.
2.
Set the blade height approximately
1
⁄
4
" higher
than the workpiece thickness by turning the
blade height handwheel, then lock the blade
height in place by tightening the blade height
lock.
3.
Adjust the fence to the desired width of cut,
then lock it in place by firmly pushing the
fence lock down until it stops.
Damage to your eyes, lungs, and ears could
result from using this machine without
proper protective gear. Always wear safety
glasses, a respirator, and hearing protection
when operating this machine.
Loose hair and clothing
can get caught in machin-
ery and cause serious per-
sonal injury. Keep loose
clothing and long hair
away from machinery.
NOTICE
If you have never used this type of machine
or equipment before, WE STRONGLY REC-
OMMEND that you read books, trade maga-
zines, or get formal training before begin-
ning any projects. Regardless of the con-
tent in this section, Grizzly Industrial will
not be held liable for accidents caused by
lack of training.
Keep the blade guard in
the down position at all
times. Failure to do this
could result in serious
personal injury or death.
Figure 36.
Basic table saw controls.
Blade Tilt
Handwheel
ON/OFF
Switch
Blade Height
Handwheel
Blade Height
Lock
Blade Tilt
Lock
Digital
Readout
Fence
Lock
4.
The digital readout displays the current blade
angle when the handwheel is moved and
power is connected to the table saw. See
Page 50
for setting the digital readout.
Summary of Contents for EXTREME G0605X
