-22-
G0605X/G0606X Extreme Series 12" Table Saw
3.
Place the extension table assembly upright
with the feet on the ground, align the slots in
the extension table bracket with the rear rail
mounting holes, then fasten the table to the
rail with two M8-1.25 x 16 flange bolts and
hex nuts shown in
Figure 22
.
Figure 23
. Fence tube mounted to front fence
rail.
Figure 22
. Outfeed table fastened to rear rail.
Flange Bolts
4.
Secure the lower shelf brackets to the sup-
port legs and cabinet with four M6-1 x 12 hex
bolts, four flat washers and two hex nuts.
5.
Install the lower shelf on the brackets.
6.
Place the fence tube over the front rail and
secure with nine M8-1.25 x 12 flange bolts as
shown in
Figure 23.
Flange Bolt
Saw Blade
Review this section, even if your saw blade came
pre-installed.
To install the blade:
1.
DISCONNECT THE SAW FROM POWER!
2.
Push a piece of scrap wood against the blade
to prevent the blade from rotating, then use
the arbor wrench to loosen the arbor nut.
Note:
The arbor nut has right hand threads;
turn it counterclockwise to loosen.
3.
Remove the arbor nut and the outer arbor
flange.
4.
Slide the blade over the arbor
with the teeth
facing the front of the saw as shown in
Figure
24
.
The saw blade is extremely sharp. Use extra
care when handling the blade or working
near it. Serious injury is possible.
5.
Re-install the arbor flange and the arbor nut,
and tighten them against the blade with the
wrench included with the saw. DO NOT over-
tighten.
Figure 24.
Correct blade direction.
Front Of Saw
Teeth Direction
& Blade Rotation
Bracket
Summary of Contents for EXTREME G0605X
