Grizzly EXTREME G0605X, Owner'S Manual

Page: 25 / 76

G0605X/G0606X Extreme Series 12" Table Saw
-23-
Table Insert
You MUST install the table insert before operating
the table saw.
Components and Hardware Needed: Qty
Table Insert ........................................................1
Flat Head Screw M5-.8 x 20 ............................. 1
To install and adjust the table insert:
1. DISCONNECT THE SAW FROM POWER!
2. Place the table insert into the table and tight-
en the screw shown in
Figure 25 .
3. Place a straightedge across the table and the
table insert.
4.
Use a 3mm hex wrench and straightedge to
adjust the table insert flush with the table as
shown in
Figure 26 .
NOTICE: The table insert must be flush with the
table top or the workpiece will hit the edge of the
table insert at the beginning of the cut.
Figure 26.
Adjusting the table insert.
4. Reinstall the table insert and secure it with
the screw removed in
Step 2
.
Figure 27
. Splitter installed.
Bracket
Lever
Splitter
Blade Guard and
Splitter
You MUST install the blade guard and splitter
before operating the table saw.
Components and Hardware Needed: Qty
Splitter ............................................................... 1
Blade Guard ...................................................... 1
To install the blade guard:
1.
DISCONNECT THE SAW FROM POWER!
2.
Raise the blade up all the way, unscrew the
screw on the table insert, and remove the
insert.
3.
Lift the lever shown in
Figure 27
, insert the
splitter into the bracket slot, and turn the lever
down to lock the splitter.
Figure 25. Table insert screw.
Table Insert
Screw