Grizzly EXTREME G0605X, Owner'S Manual

Page: 22 / 76

-20-
G0605X/G0606X Extreme Series 12" Table Saw
5.
While an assistant holds the extension table,
fasten the front rail to the extension table with
three flat head screws, flat washers and hex
nuts (
Figure 15 ). Finger tighten for now.
6. Fasten the rear rail to the extension table with
three cap screws, lock washers (outside), flat
washers, and hex nuts (inside), as shown in
Figure 16
. Finger tighten for now.
Figure 15 . Front rail/table fastener locations.
7. Level the table and extension table with a
straightedge (
Figure 17
), then tighten the
fasteners in Figure 15 with a 5mm hex
wrench and 12mm wrench.
Figure 16
. Rear rail/table fastener locations.
8.
Repeat the leveling procedure and tighten
the fasteners in Figure 16 with a 6mm hex
wrench and 12mm wrench.
9.
Using a 17mm wrench, tighten the hex bolts
shown in Figure 14 .
10. Thread a
3
⁄
8
-16 hex nut on each foot and
thread the feet into the bottom of the support
legs as shown in
Figure 18 .
Figure 18 . Foot installed on support leg.
Figure 17 . Leveling main extension table.
Foot
Support Leg
Hex Nut