Grizzly EXTREME G0605X, Owner'S Manual

Page: 27 / 76

G0605X/G0606X Extreme Series 12" Table Saw
-25-
Figure 31
. Switch installed.
Figure 32 . Miter gauge installed.
Washer
Handle
2. Slide the miter gauge into the miter gauge
slot to the left of the blade; or store it tempo-
rarily on the brackets near the blade angle
handwheel.
Components and Hardware Needed: Qty
Miter Gauge ....................................................... 1
Miter Gauge Handle .......................................... 1
Flat Washer 8mm .............................................. 1
To install the miter gauge:
1. Install the miter gauge handle and 8mm flat
washer onto the miter gauge as shown in
Figure 32 .
Miter Gauge
Fence Components
Components and Hardware Needed: Qty
Fence Knob ....................................................... 1
Fence Resting Brackets .................................... 2
Flange Bolts M8-1.25 x 12 ................................. 2
To install the fence knobs, fence, and fence
resting brackets:
1.
Install the fence knob as shown in
Figure
33 .
Figure 33 . Fence knob installed.
2. Install the fence onto the table to the right of
the blade.
3.
Install the fence resting brackets (
Figure 34
)
onto the cabinet under the Outfeed Table
with two flange bolts.
Figure 34
. Fence resting brackets installed.
Brackets
Stop Paddle
Flange Bolt
Anti-Start
Safety Pin