Grizzly EXTREME G0605X, Owner'S Manual

Page: 21 / 76

G0605X/G0606X Extreme Series 12" Table Saw
-19-
Extension Table
2.
Fasten the rear rail to the table with five cap
screws and lock washers as shown in Figure
13
.
3.
Thread two M10-1.5 x 25 hex bolts with flat
washers onto the right side of the table saw
cabinet as shown in
Figure 14
. Do not fully
tighten the bolts.
Figure 14 . Hex bolts installed.
4.
Place the extension table between the rails
and slide the table slots over the bolts
installed in
Step 3
.
Figure 13
. Rear rail installed.
Components and Hardware Needed: Qty
Table Saw Unit .................................................. 1
Front Rail ........................................................... 1
Rear Rail ........................................................... 1
F ront (Main) Extension Table ............................ 1
Lower Shelf ........................................................ 1
Shelf End Plate .................................................. 1
Support Legs ..................................................... 2
Lower Shelf Brackets ........................................ 2
Cap Screws M8-1.25 x 25 ................................ 8
Flat Head Screws M8-1.25 x 25 ....................... 8
Flat Washers 8mm ........................................... 6
Hex Nuts M8-1.25 ............................................ 6
Lock Washers 8mm ......................................... 8
Hex Bolts M6-1 x 12 ......................................... 4
Hex Bolts M10-1.5 x 25 .................................... 2
Feet
3
⁄
8
-16 x 2 ................................................... 2
Phillip Head Screws M6-1 x 12 ...................... 12
Hex Nuts M6-1 ................................................. 2
Hex Nuts
3 ⁄
8
-16 ................................................. 2
Flat Washers 6mm ......................................... 16
Flat Washers 10mm .......................................... 2
Figure 12
. Front rail installed.
To install the front and rear rails:
1. Fasten the front rail (larger of the two) onto
the table saw with five flat head screws as
shown in
Figure 12 .
Hex Bolts