Grifo SEP 40, User Manual

Page: 98 / 118

grifo ®
ITALIAN TECHNOLOGY
Page 88
SEP 40 Rel. 3.10
Reload Count down button in Statistics panel reloads initial value to Count down.
Device / Device options / Associated file
This command is used for setting associated file with current device. This is a file, which can be
automatic loaded to buffer after device is selected from default devices select list or by start
control program.
You can edit the associated file name in file name box, put a full pathname. The control program
checks the present of this file on the disk. Also is possible enabling or disabling automatic load
of this file.
You can save both settings i.e. associated file and enabling of automatic load of this file to disk
by command File / Exit and save.
Device / Blank check
This command allows to blank check of all devices or its part if possible. The control program
reports a result of this action by a write of a warning message to INFO window.
The menu command Device / Device options / Operation options allows to set another working
area as the standard.
Device / Read
This command allows to read all device or its part into the buffer. The control program reports
a finish of this action by write a message to INFO window.
The menu command Device / Device options / Operation options allows to set another working
area as the standard. Setting an option Verify data after reading in this menu command means a
higher reliability for device reading.
Device / Verify
This command compares the programmed data of the all device or its part with data in buffer. The
control program reports a result of this action by a write of an error message to INFO window.
The menu command Device / Device options / Operation options allows to set another working
area as the standard.
By the setting in the menu Options / Display errors the command lets to write the found errors
on the display or write the found errors to VERIFY.ERR file. In the Display errors mode to the
screen can display the program max. 45 the first found differences, which are located by the
address where they were caused.
Device / Program
This command allows to programming of the all device or its part by the data of the buffer. The
control program reports a result of this action by a write of an error message to INFO window.
The menu command Device / Device options / Operation options allows to set another working