Pellet burner GP xx sc 29
6.6.
MENU DISPLAYING A LIST WITH THE LAST FAILURES, OCCURRED DURING
OPERATION OF A PELLET BURNER FROM SERIES “GP XX SC”.
To check the last failures that have occurred during operation of the burner it is necessary to
enter the menu “LOG”.
The menu LOG shows a list only with the last 10 failures, which have occurred
during operation of the burner. In case a new failure occurs it replaces the oldest
one in the list.
Figure 6.13. The controller’s display panel shows the chosen menu “LOG” together with the
failure sequence number and code.
To exit this menu press the button “ESC”.
Table 7.2 provides information about the failure code and its explanation.
6.7.
RESTART OF THE PELLET BURNER OPERATION.
The burner restarting is necessary in situations when there is assignment for operation, but
the control module has switched to secured mode and the burner is not operating. The
display panel shows a message with the failure code. The reason for the failure has to be
determined and the relevant corrective measures performed. After that the burner has to be
restarted – it can be performed by switching OFF and then back ON the electrical supply of
the main module (for example through the main switch of the control board to which the
burner is connected).
6.8.
DESCRIPTION
OF
THE
TEMPERATURE
STICKERS
FUNCTION
FOR
MONITORING OF THE SYSTEM’S CONDITION.
The temperature sticker is used for measurement of the burner temperature in specific zone.
Through such measurement the system’s condition can be determined, as well as the
necessity for prevention and servicing actions to the appliance, to which the burner is
mounted and/or to the flue tract and more specifically the chimney.
S
_
+
ESC
LOG error: 1: 22
EXIT
Summary of Contents for GP 18 sc
Page 39: ...Pellet burner GP xx sc 39...
