XCU UXF Fiber Series XF Transmission Fiber Base Station User’s Guide (v1.3)
75
Chapter 6 - XCU menu reference
6.5 Security menu
SDI Live Src
SDR, HDR
SDR
User 3
Selects SDR or HDR for the
SDI Out
signal on
the — E — connectors when HDR is enabled on
the camera.
Note: the XDR eLicense is needed on the
camera.
SDI Live Mode
Combined,
1 Phase, 2 Phases,
3 Phases
Combined
User 3
Selects the method of combining the high-speed
phases for the
Live
signal on the — D —
connectors when XCU runs in high speed video
mode:
Combined: all phases (3 or 6) are combined to
obtain the highest signal level for live viewing.
Note: Some blurring may occur when panning or
tilting.
1 Phase: only 1 phase is used to obtain highest
sharpness but lower video levels.
2 Phases: two phases are used (only for XS (=6X)
video mode)
3 Phases: three phases are used (only for XS
(=6X) video mode)
3G Output
Level A, Level B
Level A
User 3
Selects SMPTE 425M Level A or Level B
mapping to be used for the
Main Video
signal
when XCU runs in 3G (1080p) video mode.
Level A: direct mapping
Level B: dual link mapping
2SI Payload ID
2SI
2SI, 3G
User 3
Selects Payload ID for 4K video modes:
2SI = 2 sample interleave
3G = (=SDQS) Square Division Quad Split
Note: this is a setting for backward compatibility
only.
SD AspectRatio
16:9, 4:3
16:9
User 3
Selects video aspect ratio for SD outputs
HDSDI LensData
Off, On
Off
Service
<Advanced settings>
Menu item
Settings
Default
Level
Description
Menu item
Settings
Default
Level
Description
Installed level
User0 .. User3
User 0
User 0
Selects XCU user level.
Note: switch the unit off and on to take the changes
into effect.
PIN Code
<code>
—
User 2
Enter a PIN code to access Service level
DeviceID Reset
Exec, ...
Exec
Service
Resets DeviceID to its factory value.
Factory Defaults
Exec, ...
Exec
Service
Resets all settings to their factory defaults.
Clear NVRAM
Exec, ...
Exec
Service
Clears Non Volatile RAM
