38
XCU UXF Fiber Series XF Transmission Fiber Base Station User’s Guide (v1.3)
Chapter 4 - Media Network configuration
Port A1 IP
— this is the local IP address of Port A1 in the Media Network. It is recommended
to use an IP address in the
10.11.5.xxx
range.
Port A2 IP
— this is the local IP address of Port A2 in the Media Network. It is recommended
to use an IP address in the
10.11.5.xxx
range.
Subnet mask
— for most situations the subnet mask is set to
255.255.0.0
. This is also the
default value.
Default gateway
— for most situations the default gateway is set to
10.11.5.1
. This is also the
default value.
☞
Note
☞
Note
Do not use IP address
10.11.5.1
as it is already in use for the default gateway. If you still want to
use this address then you must enter a different default gateway.
Make sure to set unique IP addresses for each camera system in the Media Network to avoid
network conflicts.
Media Network port B setup
The IP Media Port B tab is identical to the Port A tab and contains all settings for Port B which
is used for a secondary stream to operate in IP Redundancy mode. Refer to
for more information about IP Redundancy.
4.3.2 Main video
In the IP Main A tab you can set up IP address and port number for the Main video outgoing
stream for the primary Media Network Port. The transport protocol for Main video is also
selected in this tab.
Present indicator for Main video (sub) stream:
Off
(Sub) stream is disabled
(Sub) stream is enabled and stream is active.
(Sub) stream is enabled but stream is not active.
