52
XCU UXF Fiber Series XF Transmission Fiber Base Station User’s Guide (v1.3)
Chapter 4 - Media Network configuration
Click the camera system you want to set up. The edit popup window appears in which you can
edit the following parameters:
Reference Source
— select the source of the video reference to which the camera system
locks. When
RefVideoIn
is selected the camera system locks to the Reference input signal on
the BNC REF IN connector (can be HD Tri-Level sync or SD Black Burst), when
PTP
is selected
the camera system configured to lock to a PTP grandmaster reference clock on the Media
Network.
PTP
Status
— shows PTP locking status. The following status indications are possible:
Profile
— select the PTP protocol/domain used for locking to the PTP grandmaster; either
SMPTE2059
,
AES67, AES-SMPTE or User
.
When
User
is selected the parameters
Domain Nr
,
Delay Req Interval
and
Receipt Timeout
must be set. For more information about these paramenters, refer to the IEEE1588 PTP
(Precision Time Protocol) specification.
Tip
✎
Check the ‘Apply settings to all camera systems’ box and press OK to apply the (changed)
settings in this window to all camera systems (where applicable).
locked
XCU is locked to the PTP grandmaster clock.
calibrating
XCU has found a PTP grandmaster and is calibrating to the
grandmaster.
listening
XCU is searching for a PTP grandmaster on the Media
Network
disabled
PTP is switched off (for example when Reference Source =
RefVideoIn)
off
XCU is not connected to the Media Network.
