XCU UXF Fiber Series XF Transmission Fiber Base Station User’s Guide (v1.3)
41
Chapter 4 - Media Network configuration
With the 4K Output compression mode set to
Uncompr
, click the camera system you want to
configure. A popup window appears in which you can set the following parameters:
Main Video
Enabled
— selects whether the Main video is included in the Media Network stream and to
which port the stream is sent:
Port A
: Main video is routed to Port A (default setting).
Port A+B
: Main video is routed to both Port A and B to enable redundant network
for more information about IP
Redundancy.
Off
: Main video is NOT inserted into the Media Network stream (this is also indicated with
the indication
off
in front of stream 1).
Protocol
— this is the transport protocol for IP Main Video. Select either
ST2022-6
(‘embedded
SDI with audio and anciliary data over IP’) or
ST2110-20
(‘Video essence over IP’).
4K Output
— in this case
Uncompr
is selected.
Stream config
— defines how streams 2,3 and 4 are configured, based on settings for stream
1:
AutofillIP
: the IP addresses for stream 2, 3 and 4 are automatically filled in based on the
entered IP address for stream 1. The last digit of the IP address for Stream 1 is increased
by 2 for the subsequent streams.
AutofillPrt
: the port numbers for streams 2, 3 and 4 are filled in based on the port number
entered for stream 1. The port number is subsequently raised by 1.
In case of a single destination unicast/multicast address, the port number of the first
stream is entered and the port number for the subsequent streams is increased by 1.
