GRASS VALLEY KARRERA, User Manual

Page: 215 / 370

KARRERA — User Manual 215
Transitions
To allow both mix and wipe transitions, release the partition of a full ME in
the User Setups, Suite Prefs, Resource Allocation menu. For mix-only, you
can release and allocate an ME 50 or “half ME” resource.
Aux bus transitions can be recalled in a macro but are not E-MEMable,
however the macro can be embedded in an E-MEM
(see Macros and E-MEMs on page 143 ).
Aux Bus Transitions
1. Go to the User Setups, Suite Prefs, Resource Allocation menu
(
Figure 106 ).
2. Touch the button(s) of the ME partition you wish to allocate as the
transition resource for the aux bus.
3. Press the
Aux Trans
button in the Application column.
4.
To change the transition rate, press the
Aux Transition Rate
parameter
button, enter a transition rate in the pop-up keypad, and press
Enter
.
5.
Select an Aux bus in the Source Ops, Aux Buses menu.
6. Press the
Mix
or
Wipe
button.
7.
Press the
Trans Lock
button if you wish the mix/wipe transition to
remain selected.
Note If locking transitions ON with the Trans Lock button, you must perform at
least one transition from the menu to initiate the Aux bus mix/wipe transition.
8. Touch the allocated Aux bus source in the scolling source list
(
Figure 107 ) to execute the transition.
Note If you attempt an Aux bus transition while all allocated ME transition
resources are in use, the Aux bus will perform a cut (not a transition). For
example if during a long transition where allocated resources are all in use,
and you switched sources during the transition, the Aux bus would ‘cut’ to
the selected source (it would not mix or wipe).