Graco LDM5, Instructions Manual

Page: 9 / 20

Meter Setup and Operation Instructions
3A1451C 9
Setup Menus (F
IG
. 10)
1. If the display is blank (asleep), wake it up by press-
ing any button on the keypad (F
IG
. 10).
2. Press and hold the Total and
Reset buttons simultaneously
for approximately six (6) sec-
onds to enter the Setup
Menus (F
IG
. 10).
NOTE: During the first 4 seconds
all segments display. Then for 2 seconds the software
version number displays.
3.
There are three (3) Setup Menus available, stored in
a preset order.
a. The first screen displayed is the Resettable
Total Menu. When this menu is displayed,
R-TOTAL will blink on the screen (F
IG
. 11).
b. Press and hold Reset but-
ton to display Units of
Measure Menu. When
this menu is displayed the
last set Unit of Measure-
ment blinks on the screen
(F
IG
. 12).
c. Press and hold Reset button again to display
Calibration Menu. When this menu is displayed
CAL blinks on the screen (F
IG
. 13).
The total that is displayed when you leave each
menu is the total that is stored.
NOTE: The following sections of this manual provide
instructions for using the Setup Menus.
Resettable Total (F
IG
. 11)
Resets dispensed total on screen to zero or stores dis-
played dispense total. The resettable total accumulates
until the next time it is manually reset.
1. If Resettable Total Menu is not already displayed,
complete steps 1 and 2 of Setup Menus section.
2. R-TOTAL blinks indicating you are on the Resetta-
ble Total Menu. The currently stored total and unit of
measurement is displayed (F
IG
. 11).
3. Do ONE of the following.
a. Press and hold the Total
button. Resettable total is
set to zero (0).
0 GAL/QTS/PTS or 0
LITERS is displayed.
b. Press and hold the Reset
button. The zero (0) total
is stored. Units of Mea-
surement Menu displays.
OR
F
IG
. 10
0D[LPXP:RUNLQJ3UHVVXUHEDU36,
*$/
476 376
/,7(56
5727$/
$872
ti12044a
F
IG
. 11
*$/
476 376
/,7(56
5727$/
$XWR
0D[LPXP:RUNLQJ3UHVVXUHEDU36,
ti12047a