Screen
Screen
Screen Navigation
Navigation
Navigation and
and
and Editing
Editing
Editing
Refer to this section if you have questions about
screen navigation or about how to enter information
and make selections.
All
All
All Screens
Screens
Screens
1.
Use
to move between screens.
2.
Press
to enter a screen. The first data field
on the screen will highlight.
3.
Use
to highlight the data you wish to
change.
4.
Press
to edit.
Drop
Drop
Drop Down
Down
Down Field
Field
Field
1.
Use
to highlight the correct choice from
the dropdown menu.
2.
Press
to select.
3.
Press
to cancel.
Number
Number
Number Field
Field
Field
1.
The first digit will be highlighted. Use
to change the number.
2.
Press
to move to the next digit.
3.
When all digits are correct, press
again to
accept.
4.
Press
to cancel.
Check
Check
Check Box
Box
Box Field
Field
Field
A check box field is used to enable or disable features
in the software.
1.
Press
to toggle between
and an empty
box.
2.
The feature is enabled if a
is in the box.
Reset
Reset
Reset Field
Field
Field
The reset field is used for totalizers. Press
to
reset the field to zero.
When all data is correct, press
to exit the screen.
Then use
to move to a new screen, or
to move between Setup screens and Run screens.
Initial
Initial
Initial Setup
Setup
Setup
NOTE:
NOTE:
NOTE: Before creating the pump profiles in Setup
Screens 1 through 4, you must set up the system
parameters in Setup Screens 5 through 14, as
follows.
1.
Press
to enter the Setup screens. Setup
Screen 1 will appear.
2.
Scroll to Setup Screen 5.
3.
See
, and select the
lower used in your system.
4.
Continue setting the system parameters
on
through
5.
Scroll to Setup Screen 1. Establish
the profiles for each pump. See
through
6.
When the profiles are set to achieve the desired
pressures and flow rates, start the pump. Go to
. Check the box next to
to perform an automatic system calibration.
The system will learn its optimum settings over
21 cycles.
3A3453H
21