Operation
Operation
Operation
Startup
Startup
Startup
To operate the pump, follow the Startup instructions
for the Advanced motor in the Motor manual.
Run the pump at a slow speed until the fluid lines are
primed and all air is forced out of the system.
Shutdown
Shutdown
Shutdown
Follow the
Pressure Relief Procedure, page 17
Pressure
Pressure
Pressure Relief
Relief
Relief Procedure
Procedure
Procedure
Follow the Pressure Relief Procedure
whenever you see this symbol.
This equipment stays pressurized until pressure is
manually relieved. To help prevent serious injury
from splashing fluid and moving parts, follow the
Pressure Relief Procedure when you stop spraying
and before cleaning, checking, or servicing the
equipment.
1.
Disengage the start/stop control (C).
See
2.
Shut off and lock out the fused safety switch (B).
3.
Open the fluid drain valve (H), having a waste
container ready to catch drainage. Leave open
until you are ready to pressurize system again.
Control
Control
Control Module
Module
Module Overview
Overview
Overview
The Control Module provides the interface for users
to enter selections and view information related to
setup and operation.
The screen backlight is set to turn off after 10 minutes
of inactivity.
Keys are used to input numerical data, enter setup
screens, navigate within a screen, scroll through
screens, and select setup values.
Control
Control
Control Module
Module
Module Cable
Cable
Cable Connections
Connections
Connections
Control
Control
Control
Module
Module
Module
Port
Port
Port
Number
Number
Number
Connector
Connector
Connector Purpose
Purpose
Purpose
1
Fiber Optic RX - to PLC
2
Fiber Optic TX - to PLC
3
Power and CAN communication
4
Start/stop input
5
Fiber Optic RX - to next ADCM
6
Fiber Optic TX - to next ADCM
7
Pressure transducer 1
8
BPR control 4-20mA output
9
Agitator control 4–20 mA output
10
Pressure transducer 2
3A3453H
17
