![background image](http://html1.mh-extra.com/html/graco/e-flo-17v232/e-flo-17v232_instructions-parts-list-manual_2251116004.webp)
Control
Control
Control Module
Module
Module
The Control Module provides the interface for users to enter selections and view information related to setup
and operation.
The screen backlight is factory set to remain on, even without screen activity. See
to
set the brightness and backlight timer. Press any key to restore the settings.
Keys are used to input numerical data, enter setup screens, navigate within a screen, scroll through screens,
and select setup values.
Installation
Installation
Installation
Install
Install
Install the
the
the Control
Control
Control Module
Module
Module
1.
Shut off and lock out power to the motor.
2.
For single phase models only, install the jumper
connector (5) over the top two terminals of the
motor, using the screw (5a). Three phase models
do not have a jumper connector.
NOTE:
NOTE:
NOTE: To connect up to 8 motors together,
see Appendix A in the E-Flo DC Motor Manual
(3A2526), where the control module is the
referenced intrinsically safe (IS) apparatus.
NOTE:
NOTE:
NOTE: See Appendix C for information about
different multi-unit topologies.
3.
Assemble the bracket kit (6a-6f) and the holder
and tie (11, 12) as shown.
4.
Install the module (1) in the bracket (6a), making
sure the tabs at the bottom of the bracket engage
the slots in the module, and the lip at the top of
the bracket holds the module securely in place.
5.
Connect the accessory cable (C), using the
tie (12) as a strain relief as shown. See
6.
Restore power to the motor.
Figure 1 Install the Control Module (Single Phase
Model Shown)
4
3A2527H