Cable
Cable
Cable Connection
Connection
Connection
Order an accessory cable (C) from Table 1. Connect the cable to Port 3 on the bottom of the control module
(see Fig. 2). Connect the other end to the power terminal (PT) on the motor (see Fig. 3). Connect other
cables as described in Table 2.
Table
Table
Table 1
1
1 CAN
CAN
CAN Cables
Cables
Cables
Cable
Cable
Cable Part
Part
Part
No.
No.
No.
Description
Description
Description
16P911
Intrinsically safe CAN cable, female
x female, 3 ft (1 m)
16P912
Intrinsically safe CAN cable, female
x female, 25 ft (8 m)
Table
Table
Table 2
2
2 ADCM
ADCM
ADCM Cable
Cable
Cable Connections
Connections
Connections
ADCM
ADCM
ADCM Port
Port
Port
Number
Number
Number
Connector
Connector
Connector Purpose
Purpose
Purpose
1
Fiber Optic RX - to Fiber Optic
Converter Module
2
Fiber Optic TX - to Fiber Optic
Converter Module
3
Power and CAN communication
4
• Start/Stop input (pin 2)
• Fill pump output (pin 3)
• Reed switch input (pin 4)
• Agitator halt input (pin 4)
• Tank high output (pin 4)
• Tank low output (pin 4)
• Auxiliary output (pin 4)
5
Fiber Optic RX - to next ADCM
6
Fiber Optic TX - to next ADCM
7
Pressure transducer 1
8
BPR control 4-20mA output
9
Primary Tank Level Monitor
10
Pressure transducer 2
Figure 2 ADCM Connectors
Figure 3 Motor Power Terminal
3A2527H
5
