![background image](http://html1.mh-extra.com/html/graco/dyna-star-3a6941j/dyna-star-3a6941j_instructions-manual_2253485007.webp)
Installation
3A6941J
7
Fuses
Mounting
Note: Upper case letters used in the following
Typical Installation: Single Line
(F
. 5),
. 6),
. 7), and
. 8) diagrams starting on page 9.
Securely mount and ground the unit before
operation.
1. Mount the tank (K) on a sturdy, flat surface with
user-provided bolts. Install so that the fill port (F)
and the lubricant outlet connection (P or AC) are
easily accessible after installation.
2. Connect the controller (F) (if used).
3. Connect a high pressure lubricant supply line (D) to
the lubricant outlet connection (P or AC).
4. Connect all electrical connections. See
Wiring: Single Line Parallel Systems
page 11.
5. Ground the system. See
page 6.
Pump
The pump provides lubricant flow and pressure to oper
-
ate an automatic lubrication system.
Single Line Parallel System
The pump requires an electrical power supply and a
timed signal from a lubrication controller (F). The pump
provides lubricant flow and pressure to operate the
injectors (E), and vents the injector system to reset the
injectors.
Series Progressive System
The pump requires an electrical power supply and a
timed signal from a lubrication controller (F). The pump
provides lubrication flow and pressure to operate
metering devices (AD).
Inlet and Outlet Components
NOTICE
Fuses (user supplied) are required on all models. To
avoid equipment damage:
• Never operate the pump without a fuse installed.
• A fuse of the correct voltage and amperage must
be installed in line with the power entry to the sys
-
tem. Graco recommends using a 10A time delay
fuse.
LIFTING HAZARD
This equipment is heavy. Lifting or moving heavy
equipment incorrectly can cause serious injury such
as muscle strain or back injuries. To avoid injury:
• Do not lift or move this equipment without assis
-
tance.
• Always use a lifting device secured to the pump
when moving or installing this equipment. See
weight.
The breather (J) vents the tank to the atmosphere. If it
is plugged the tank will over-pressurize and rupture.
Be sure the breather is not plugged before filling the
pump.
COMPONENT RUPTURE HAZARD
The maximum working pressure of the inlet and out
-
let components in the system vary. Over-pressurizing
an inlet or outlet can cause components to rupture,
potentially resulting in serious injury such as skin
injection or injury from splashing fluid. To reduce the
risk of component rupture:
• Be sure to know the maximum working pressure
of each inlet and outlet component in the system.
•
Never
exceed the maximum working pressure of
the inlet and outlet components.
Summary of Contents for Dyna-Star 3A6941J
Page 11: ...Installation 3A6941J 11 Typical Wiring Single Line Parallel Systems FIG 7...
Page 30: ...Maintenance 30 3A6941J 35 Remove the check valve and o ring 37 FIG 49 FIG 49 37...
Page 44: ...Parts 44 3A6941J 43 42 41 58 59 52 55 56 57 54 47 48 49 50 51 53...
Page 51: ...Mounting Dimensions Stand Alone Pump 3A6941J 51 Mounting Dimensions Stand Alone Pump...