Operation
22
3A6941J
Level Transducer
The level transducer (S) (F
. 22) is used for continuous
level monitoring. It indicates a fault when the follower
plate (Y) reaches the factory set distance from the
bottom of the tank. The fault activates when the
remaining grease level is approximately 10 percent.
Light Indicator
NOTICE
The pump (B) should not be run without grease, or air
will be introduced into the system and could cause
damage.
Output type:
1 analog output 0 - 10V
Operating voltage: 10 - 30 VDC
Current:
200mA
Connection type:
M12x1, 4 pin
Normal:
Green
Low-Level:
Yellow
Error:
Red
F
IG
. 22
Summary of Contents for Dyna-Star 3A6941J
Page 11: ...Installation 3A6941J 11 Typical Wiring Single Line Parallel Systems FIG 7...
Page 30: ...Maintenance 30 3A6941J 35 Remove the check valve and o ring 37 FIG 49 FIG 49 37...
Page 44: ...Parts 44 3A6941J 43 42 41 58 59 52 55 56 57 54 47 48 49 50 51 53...
Page 51: ...Mounting Dimensions Stand Alone Pump 3A6941J 51 Mounting Dimensions Stand Alone Pump...