Software
English, Revision 04, Date: 19.01.2015
32
3.
Montrans.txt
Transfer if the system is adjusted to procedure
Transparent
with “
HighByte
first
“. The file contains the characters:
0x3D 0x4D 0x4F 0x4E 0x49
0x38 in hexa-decimal notation.
4.
Transmon.txt
Transfer if the system is adjusted to procedure
Transparent
with “
LowByte
first
“. The file contains the characters:
0x3D 0x4F 0x4D 0x49 0x4E
0x38in hexa-decimal notation
Using HyperTerminal the file is transferred as follows:
1.
Select
Send Text
file in the menu
Transfer
. The following window will
appear:
2.
Switch to disc drive (in our example, the files are located on the hard disc) and
select the respective *.txt file.
3.
Click
. The file will be transferred and (once the corresponding file has
been selected) the monitor program will be started. The menus will then appear
directly within the HyperTerminal Window. First, the main menu from Figure 17
on page 33 will appear.
5.3.2
How to work with the monitor program
ATTENTION!
Effect only alterations on values for the system interface as posi-
tioning accuracy will decrease if the calculation coefficients are
altered!
Any change to the interface parameters will be only activated after a system reset (turn
antenna off and on). Afterwards it may be necessary to use a different file from the four
given *.txt documents to start the monitor!
After the transfer of the *.txt file (refer to section 5.3.1) the monitor program starts with
the main menu. If it does not, you have either based your settings on a wrong system
configuration, or you are using a different terminal emulation and did not adjust the
character delay to 1 ms, or you did not wait at least 10 s (26 s) after activating the An-
tenna.
