Software
English, Revision 04, Date: 19.01.2015
39
With
or with the
or
keys you may tune the transmitting antenna by switching
the power consumption to max. (resulting in the largest reception range).
enables
switching the transmitter on (
1
) or off (
0
) for control reasons.
is automatically set to
1
upon leaving the monitor.
enables activating auto tuning. Following each system switch on, the transmitter cy-
cle is retuned. This procedure takes approx. 16 sec. After that, every 10 sec. the tun-
ing is re-checked (as long as there is no transponder within the field) and re-tuned if
necessary.
5.3.2.5
C(A)N-Parameters
This menu enables setting the various CAN Bus parameters. Before being able to use
the CAN bus interface it is essential to activate it by pressing
.
Figure 23
Menu: C(A)N-Parameters
Entering
enables the generation of telegrams either as standard frames according
to CAN2.0A or as extended frames according to CAN2.0B. Correspondingly it is pos-
sible to either set the Identifier
(CAN address) as 11 bit value (0-2047) or as 29 bit
value (0-536870911).
The identifier selectable under
corresponds to the transmitted frames for the Mes-
sage Object 1 (refer to Table 5 on page 25). The identifier selectable under
refers
to the Message Object 2 (refer to Table 6 on page 26),
refers to the Message Object
3 (refer to Table 7 on page 26). Input of 0 deactivates the corresponding Message Ob-
ject.
With
it is possible to change the CAN baudrate.
enables either the activation of a permanent output of the
Clock for Sampling
which can be set by pressing
(
1
), or the activation of an output that is only gener-
ated whenever a Transponder is within the reception range (
0
).
S:0006 D:+005 D_Y:+32767 D_X:+32767 Code: 0000 Read: 0: N: 1
Frx[/Hz]:61280 Ftx[/Hz]:127990 CSEL: 1
U[/mV]:24200 I[/mA]: 270 T[Grd.C]:+19 S_MA: 0000 S_SL: 0000 Noise 0
SR = 00: NO ERROR / / / /
(C)AN active NO
E(X)tended CAN STANDARD
(I)dentifier: TX [0..2047]: 10
(A)-Identifier: TX [0..2047]: 0
(D)-Identifier: TX [0..2047]: 0
CAN-(B)aud [20,50,125,250,500,1000 kB]: 1000.0
or
B(R)P Baudrate Prescaler [0..63]: 0
(S)JW Sync Jump Width [0..3]: 0
Tseg(1) [2..15]: 6
Tseg(2) [1..7]: 1
resulting sample point: 70 %
(P)eriod [4.500mS]: 8
Co(n)tinous Telegrams 1
CAN on Re(m)ote Request 0
(F)reeze Values for n Telegrams [0..20]: 0
(esc) to quit
