Software
English, Revision 04, Date: 19.01.2015
36
Example
Only the
Displacements X and Y
, the
Code
and the
System
Status
are to be output.
Add, according to the table the values 0x0000.0001,
0x0000.0002, 0x0000.0004, 0x0000.0008 and 0x0000.1000. The
result is 0x0000.100F. Therefore the input for the “(
)elegram
Content Mask“ is 0x100F.
Using “(
)isplay Telegram Content“ it is possible to check the review telegram (also
refer to Figure 19). The shown case has a mask value of 0x0000.1fff. Pressing any key
generates the return to menu
Serial Output
.
Figure 19
Menu: „(D)isplay Telegram Content“
Parameter „(
)har Delaytime“ is the so-called Character Delay Time for procedure
3964R (refer to appendix, section A „Procedure 3964R“ on page 50) and the timeout
time for incoming characters transparent mode (refer to appendix, section B „Proce-
dure „transparent““ on page 51).
Pressing
generates the selection of the corresponding telegram procedure — 3964R
or transparent. For procedure 3964R it is also possible to set the acknowledgement
delay time.
enables choosing between the permanent output according to the set
erial
Data Period
(
1
), or output only whenever a Transponder is decoded within the read-
ing range (
0
).
enables ’freezing’ the serial output for 0 to 10 telegrams, i. e. the values at the time
of the positioning pulse output are preserved.
S:0005 D:+005 D_Y:+32767 D_X:+32767 Code: 0000 Read: 0: N: 1
Frx[/Hz]:61280 Ftx[/Hz]:127990 CSEL: 1
U[/mV]:24200 I[/mA]: 340 T[Grd.C]:+19 S_MA: 8000 S_SL: 0000 Noise 0
STX 1 Bytes from Position: 1
Delta_Y 2 Bytes from Position: 2
Delta_X 2 Bytes from Position: 4
CODE 2 Bytes from Position: 6
Usum 2 Bytes from Position: 8
Udif 2 Bytes from Position: 10
Vcc 1 Bytes from Position: 12
Current 1 Bytes from Position: 13
Temp. 1 Bytes from Position: 14
CodesRd 1 Bytes from Position: 15
Rx-Freq 2 Bytes from Position: 16
Tx-Freq 2 Bytes from Position: 18
STATUS 2 Bytes from Position: 20
(esc) to quit
