Gorilla Playsets Malibu Pioneer Peak 1500DWR, Manual, Page: 82 / 171

MAKE THIS SLAT FLUSH
TO THE END OF
THE 2 X 4 X 14" BOTTOM
PANEL BOARD. SPACE
THE NEXT SLAT EQUALLY
BETWEEN THE FIRST SLAT
AND THE CORNER
POST.
2 3
16 " SPACING TYP.
LEAVE THIS SLAT OFF UNTIL AFTER
FRONT FACE BOARD.
PANEL
2" WOOD
SCREW
FRONT PANEL SLATS
THE FRONT FACE
TO THE NOTCH ON
SLAT FLUSH TO THE SIDE OF THE
PANEL SLAT
5/4 X 2-5/8 X 28-1/4"
BEAM. ONCE THE TIRE SWING
INSTALLING THE TIRE SWING
BEAM IS IN PLACE SECURE THIS
ARE INSTALLED FLUSH
SWING BEAM. REAR PANEL
SWING BEAM
BOARD.
LEAVE THIS
SLAT OFF
UNTIL AFTER
THE CLATTER
BRIDGE IS
INSTALLED.
FRONT PANEL SLAT IS
INSTALLED FLUSH TO
THE NOTCH ON THE
SIDE PANEL
ROCK WALL SIDE PANEL
2: PRE-DRILL THE SLATS 1" FROM EACH END ON CENTER WITH A 1/8" DRILL BIT.
3: INSTALL THE PANEL SLATS AT EQUAL LENGTHS. SEE DETAIL BELOW FOR MEASUREMENTS.
1: FIND TWENTY-TWO 5/4 X 2-5/8 X 28-1/4" PANEL SLATS.
4: ATTACH THE PANEL SLATS TO THE FORT WITH 2" WOOD SCREWS IN THE PRE-DRILLED HOLES.
STEP 21: PANEL SLATS
SWING BEAM PANEL
SLAT DIMENSIONS
(VIEW FROM OUTSIDE
THE PLAY SET.)
REAR PANEL SLAT SPACING
2 34 "
74