Gorilla Playsets Malibu Pioneer Peak 1500DWR, Manual, Page: 70 / 171

LARGE HOLES SHOULD BE CLOSEST TO THE FLOOR
3/8" DRILL BIT.
2 X 4 X 18-3/4"
RAMP SUPPORT
2-1/2"
WOOD SCREW
2 X 4 X 96"
BOARD FIRST
RAMP SIDE
ROUND END
INSTALL THIS BOARD SECOND
INSTALL THIS
CHECK TO SEE IF THESE TWO HOLES
ARE DRILLED THROUGH COMPLETELY
IN THE RAMP SIDES. IF THEY ARE NOT
DRILLED ALL THE WAY THROUGH THEN
CAREFULLY REAM THEM OUT WITH A
4"
1"
44 34 "
STEP 16: CLIMBING RAMP
1: LAY OUT THE 2 X 4 X 96" RAMP SIDE BOARDS MAKING SURE THE LARGE HOLES ON TEH ENDS ARE CLOSEST TO THE
FLOOR.
2: FIRST PLACE ONE 2 X 4 X 18-3/4" RAMP SUPPORT BOARD AT THE SQUARE END OF THE 2 X 4 X 96" RAMP SIDE
BOARDS. OFFSET THE BOARD 1" FROM THE END. FASTEN THE RAMP SUPPORT BOARD TO THE RAMP SIDE BOARDS
WITH TWO 2-1/2" WOOD SCREWS PER SIDE.
3: SECOND PLACE ONE 2 X 4 X 18-3/4" RAMP SUPPORT BOARD AT THE ROUND END OF THE 2 X 4 X 96" RAMP SIDE
BOARDS. OFFSET THE BOARD 4" FROM THE ROUND END. FASTEN THE RAMP SUPPORT BOARD TO THE RAMP SIDE
BOARDS WITH TWO 2-1/2" WOOD SCREWS PER SIDE.
4: PLACE THE REMAINING 2 X 4 X 18-3/4" RAMP SUPPORT BOARD ACROSS THE RAMP SIDE BOARDS IN THE MIDDLE,
44-3/4" FROMT HE SQUARE END AND FASTEN WITH TWO 2-1/2" WOOD SCREWS PER SIDE.
NOTE: CLIMBING RAMP TO BE INSTALLED INSTEAD OF LADDER ON THIS MODEL. THE LADDER PARTS ARE INCLUDED
IN THE PACKAGE BUT ARE NOT USED.
62