11
8. Attach the Upper Shroud (17) to the Top Frame
(4) with two M6 x 16mm Screws (62) and two M6
Washers (82).
Do not tighten the Screws yet.
Attach the Lower Shroud (90) to the brackets on
the Stabilizer (2) with two M6 x 16mm Screws
(62) and two M6 Washers (82).
Make sure that
the brackets are inside the Lower Shroud.
Tighten the four Screws used in this step.
See steps 2 and 4.
Tighten the M10 Locknuts
(56) and the M8 Locknuts (58).
See step 3.
Tighten the M8 x 20mm Screws (96).
See step 6.
Tighten the M10 x 25mm Bolts (74).
See step 7.
Tighten the M5 x 20mm Self-tapping
Screws (64), the M6 x 16mm Screws (62), and
the M6 Locknuts (78).
8
62
82
17
4
62
62
82
82
Bracket
2
90
9. Apply grease to the outside of the barrel of an
M10 x 64mm Bolt Set (76).
Orient the Leg Lever (8) so that the welded sup-
port is on the side shown. Attach the Leg Lever to
the Front Leg (7) with the M10 x 64mm Bolt Set
(76).
Make sure that the barrel of the Bolt Set
is inserted through both sides of the bracket
on the Front Leg.
9
76
76
Grease
Welded
Support
7
8
Arm Assembly