Flow
Control
FC
-
s01
cordless workstation for heated paint
1. Technical specifications
The set includes:
1. FlowControl kettle
2. Inner liner with lid
3. Battery pack FC-B01
4. Charger FC-C01
Battery
Typical capacity
2600mAh
Charge voltage
27,5V
Energy
57,72 Wh
Operating temperature
Charge: 0-45
°
C
Discharge: 0-45
°
C
Storage temperature
10-35
°
C
Cycle life
>500
2. Safety instructions
WARNING!
Read all safety warnings and instructions.
Keep all warnings and instructions for future reference.
- Place the kettle upright on a dry, flat and even surface. Never place the kettle in a wet or damp area!
- Do not attempt to open the kettle, the battery pack or the charger!
- Do not allow metal objects, tools or fluids to enter the kettle housing, charger, or battery pack!
- Do not use other power adapters or battery packs other than specified.
- Do not use any charger from other manufacturers for charging the battery pack. The use of incompatible
accessories may result in electric shock and / or serious accidents!
- Change the battery pack only in a safe and stable situation (e.g. not while on a ladder or scaffolding)
to prevent the risk of it being dropped.
-
WARNING!
Danger of explosion if battery is incorrectly replaced.
- Only place the battery into battery compartment whilst using the kettle. After use remove the battery,
charge and store separately. Do NOT place the battery back into the battery compartment of the kettle
unless you will start using it immediately.
- Store in a dry place at a temperature of 10-35
°
C without connecting the battery to the kettle!
- Fully charge the battery at least once every three months!
- Protect the battery pack from excessive heat > 45
°
C or constant heat sources such as direct sunlight
or flames!
- Never use water to extinguish burning li-ion battery packs! Use sand or a fire blanket.
- Check the plug and the cable of the charger regularly and if damaged, replace with a new charger.
- Always remove the plug from the mains socket when the charger is not in use.
3. Intended use
FlowControl FS-C01 is intended for warming up paint and coatings to a maximum of 30
°
C to help to
achieve better paint flow, making it easier for the painter to apply without use of thinners. Only intended
for use by professional painters and decorators.
Not intended
for warming up flammable paints, coatings and liquids, i.e. with a flash point that is lower
than 60,5
°
C.
Not intended
for warming up liquids to temperatures higher than 30
°
C.
4. Operation. to use FlowControl FC-S01
4.1 Important instructions for battery pack
First use:
Fully charge battery pack first until the battery LED turns green. Then use until low battery
signal is indicated. Then recharge fully. Always recharge battery pack before storage. Only place the
battery in the battery compartment during use. After each use remove the battery, charge and store
separately. For storage ensure the battery is disconnected from the kettle, keep in a dry place at 10-
35
°
C. Storing a battery in a colder or hotter environment will negatively affect the battery performance
and lifetime. Also storing a battery without recharging first will negatively affect the battery performance
and lifetime. Charge the battery at least once every 3 months during inactive periods.
1
2
3
4
GB
2
