GNATUS Endus Duo R, Owner'S Manual, Page: 51 / 68

51
Counter-angle type lock-blade – Fixation of the file/drill
- Couple the counter-angle on the micromotor.
- Turn the lever counterclockwise (fig. 8).
- Introduce the drill on the orifice and turn untill it locks on the limiter (fig.09).
- By touching the limiter with the drill, turn the lever to the initial direction to lock the
drill (fig.10).
08
09
10
Counter-Angle Push Button type* - Fixation of the file/drill
- Couple the counter-angle on the micromotor.
- In the PB (Push Button) system, place the
drill on the guide and turn it until it locks inside
the limiter (fig.11). Afterwards press the head
button and displace the drill until it reaches the
bottom of the limiter, releasing the head button
(fig.12).
- Make sure that the drill is placed until the
bottom for a deep fixation (fig.13).
OBS: Use only good quality and standardized
drills. Drills with a too long shaft can produce
excessive vibration lowering the lifespan of the
bearings.
11
12 13
Connecting and disconnecting the counter-angle
07
Connecting
The counter-angle can be connected in 6 adjustable head positions. Align the positioning pins
(A) of the counter-angle with the positioning indentations (B) of the handpiece and introduce
the head until you listen a click (see fig.07).
Disconnecting
When removing the counter-angle,
pull it rectilinearly (fig.07).
A B
ATTENTION
Before connecting or disconnecting
the counter angle, turn off the
motor. Check if the counter-angles
is well placed on the handpiece.
INSTALLATION OF THE EQUIPMENT
* optional items