GLW MC 25, Operating Manual

Page: 57 / 131

TROUBLE-SHOOTING
10/12
19
Fault condition 3
Crimping is completed. Cable cannot be pulled out.
Disconnect the mains supply from the
mc 25 and open cover.
1. Stop operation

Read counter (1) if required.

Press the reverse button (2) to move the mc 25
into start position.

Turn off (position 0) the mc 25 with mains
switch (3).

Disconnect mains cable (4).
2. Remove the tool insert

Slide back the cover (1).

Pull out the bolt (2).

Press lower stripping cutter (3) upwards and
remove the tool insert (4) sideways.
!
If it is impossible to remove the tool
insert then carry out step 4, else carry
on with step 3.

Remove end sleeve (5).

Bend cable aside (6)
Diagram 23 Stop operation
Diagram 24 Remove the tool insert