GLW MC 25, Operating Manual

Page: 47 / 131

COMMISSIONING
10/12
9
1. Chose the installation site

The installation site of the mc 25 must be level and horizontal.
!
Observe the working conditions in chapter safety, section places for use.
2. Prepare the dispenser

Open the dispenser and tear-off the strap at the
edge (1).

Pull out the end-sleeves band (2) approximately
20 cm.
3. Prepare the end-sleeve feeder

Take end-sleeve feeder with proper cross-
section from the accessories box.
!
Observe to the colour code of the end-
sleeve feeder.

Insert the end sleeves (1) in the guide sideways
until the stop pin is reached.

Pull the pin (2) upwards, move the end sleeves
to the mark (3) and let the pin go.
!
Check that the pin has clicked properly
into place.
Diagram 3 Prepare the dispenser
Diagram 4 Prepare the end-sleeve feeder