•Page
globalcontract.com
32
GLOBAL
Contract
• August 2018
INSTALLATION GUIDELINES
PET Felt Carrel
FreeFit Felt Carrels 24x48,54,60 and 30x48 are formed out of one piece felt board.
Any other sizes consist of two felt pieces as illustrated.
STEP 1: Rest the bottom of the extrusion on a flat surface.
STEP 2: Measure and mark exact centre of the extrusion.
STEP 3: Align the felt with the centre mark and insert the felt partially into the extru-
sion, proceeding at an angle from one end to another.
STEP 4: Insert the second felt piece partially into the extrusion, proceeding at an angle
from one end to another. Ensure that there is no gap between the individual pieces.
STEP 5: Turn the assembly upside down, rest the exposed felt edge on a flat, clean sur-
face. Apply pressure on the extrusion while proceeding from one end to another. Ensure
that the felt is completely and evenly inserted into the extrusion along its full length.
STEP 6: Secure the top corner of felt pieces together with the supplied anodized caps.
STEP 7: Install mounting bracket to either side of FreeFit work surface. Align rear
bracket edge A with rear WS edge AA, align flat sections of slots B in the bracket with
side edge BB of the WS.
STEP 8: Secure the brackets with supplied screws, but DO NOT tighten. Allow the
brackets to move within the range of the oblong holes.
STEP 9: Rest front part of the felt in the grove between metal brackets and WS edges.
10 Align holes in brackets with screw ports in the extrusion and secure the extrusion
to the brackets with supplied Torx screws.
STEP 11: Push the brackets sideways against the WS side edge in order to clamp the
felt, and tighten the bracket screws. Ensure that the carrel is precisely entered on the
WS and both front parts of the felt are snuggly secured.
Worksurface
Side
Worksurface
Rear Edge
Line up the side edge
of the worksurface
with the “D” shaped
holes.
1
9
11
10
2
3
4
5
6
7
B
A
BB
AA
Torx Screw
7