GINA 6000N-5, 6000NV-5, 8000N-5, & 8000NV-5
GINA User’s Manual
2-5
© 2001 GRE America, Inc. All rights reserved. This material is the property of GRE America, Inc. Copying or reproducing this material
is strictly prohibited. All violators shall be prosecuted to the fullest extent of the law.
3/01 (rev. 3)
0 = OFF
1 = Permanent mode (ENR remains enabled after power
down).
2 = Temporarily ON mode (ENR disables if the power is
turned off).
Setting Transmitter Unit (Host)
1.
Set TXID (Transmitter ID) to the desired ID number (between 1
and 99).
2.
Set TXP (Transmit Path) equal to that of the RID of the Repeater
ID.
3.
Set RID (Repeater ID) to zero.
4.
Set ENR (Enable Repeater) to zero.
Setting Receiver(s) Parameters (Remote)
1.
Set TXID of the remote radio different from the TXID of the Trans-
mitter (Host) radio, 1...99.
NOTE:
If you do not want to receive the message from other
remote units, set all the remote TXID’s the same.
IMPORTANT: If the host and remote(s) TXID’s are set to the
same value, neither radio will display any data.
2.
If the receiver(s) is going to respond back to the transmitter through
a repeater, you must set the receiver(s) as follows:
a.
Set TXP (Transmit Path) equal to that of the RID of the
Repeater ID.
b. Set RID and ENR to zero.
After parameters are set, type
QUIT
to enter the transparent mode.