2-2
© 2001 GRE America, Inc. All rights reserved. This material is the property of GRE America, Inc. Copying or reproducing this material
is strictly prohibited. All violators shall be prosecuted to the fullest extent of the law.
3/01 (rev. 3)
GINA 6000N-5, 6000NV-5, 8000N-5, & 8000NV-5
GINA User’s Manual
Figure 2-1. Command Structure Flowchart
As illustrated in figure 2-1, there are three modes of operation:
1.
SETUP MODE.
The setup mode is where the parameters of GINA
can be changed. There are 17 dedicated commands that may be
altered to accommodate different timing application.
NOTE
: Any changed parameters are automatically stored in
memory.
2.
TRANSPARENT MODE.
The transparent mode converts GINA
into a mode that is completely transparent to the user. The data is
immediately transmitted if the PACWAIT or PACSIZE command
limits are exceeded.
NOTE:
To return to the setup mode from the transparent mode,
press
<CTRL> + <V>
three times in succession.
3.
PERMANENT TRANSPARENT MODE.
The permanent trans-
parent mode is similar to the transparent mode except that there is
no escape character to return to the setup mode. Once in the perma-
nent transparent mode, the only way to return to setup mode is by
turning the radio off (reset).