GILES FSH-2, Operation & Service Manual, Page: 16 / 66

6
Installation
Model: FSH-2, FSH-2A-99
2.02 Unpacking
!! IMPORTANT NOTE:
If the palletized unit showed any signs of damage, you should have immediately inspected the equipment and
any other packed accessories, and promptly notified the freight company of any and all damages. Typically, it is
the customer’s responsibility to claim freight damage .
Unit is shipped on a wooden pallet, secured by high-tensile plastic strapping and wrapped with machine-applied
stretch wrap. A wooden framework is built around the unit for added protection. Unpack unit as follows:
1. Position the unit in an area that provides adequate space for unpacking activities.
2. Remove the plastic stretch wrap, strapping and other packaging materials, as necessary.
3. Carefully remove wooden supports and/or framework that might be attached.
4. The carton containing the empty
1-1/2 gal. wet chemical suppressant tank is generally secured on top of the
hood. Locate carton and retain for safe keeping ... it will be needed by the Ansul Service Technician for field set-
up of the fire suppression system.
5. To avoid damage, unit is shipped without the adjustable legs installed. The legs are packaged in a separate
carton ... be sure to secure and retain, see Adjustable Leg Installation below.
6. Carefully remove the unit from the shipping pallet. The hood is very heavy and somewhat top-heavy, see
Section 1.06, Unit Weight . Great care should be taken when lifting or moving the unit to avoid personal injury
or equipment damage.
•
The unit is very heavy and somewhat top-heavy! Exercise due caution when handling to avoid personal injury
or damage to the equipment. Take precautions necessary to avoid damaging the hood stand or legs.
•
Exercise care when removing the protective wooden framework from around the unit to avoid exposed nails or
staples.
•
Failure to comply with these CAUTION notices may result in minor to moderate injury, damage to equipment or
property, and void the warranty.
1. Obtain the adjustable legs.
For the Model FSH-2A-99, two (2) legs are floor-plate style; the other two (2)
are standard style .
2. With appliance resting on a stable surface, have two helpers tilt the unit forward and hold.
3. Install the two (2) rear legs
(standard) into thread holes on bottom of side stand, screw in clockwise until
hand tight.
Take care not to cross-thread ... leg should turn fairly easy until tight.
4. Have helpers tilt unit backward onto the installed rear legs, giving access to front of stand. Repeat the
process for front two (2) Legs
(floor-plate).
Adjustable Leg Installation