Gilera SMT RCR 633793, Service Station Manual

Page: 44 / 118

- Check that the resistance between the terminals and the earth complies with the values indicated in
the table.
Lights list
BULBS
Specification Desc./Quantity
1 Front headlamp bulbs
12V. 35/35 W.
Type: Twin filament
2 light/stop bulb:
12 V, 21/5 W
Type: Twin filament
3 Turn indicators bulb: 12 V, 10 W
Fuses
The electrical system is protected by a 4 ampere
fuse « B » located on the fuse box « A » on the bat-
tery positive cable. Before replacing a blown fuse,
find and solve the problem that caused it to blow.
Do not substitute the fuse with any alternative form
of conductor
Sealed battery
Sealed battery start-up operations
INSTRUCTIONS FOR REFRESHING THE STOCK CHARGE OF AN OPEN CIRCUIT
1) Voltage check
Before installing the battery on the vehicle, check the open circuit voltage with a normal tester.
- If the voltage exceeds 12.60 V, the battery may be installed without any renewal recharge.
- If voltage is below 12.60 V, a renewal recharge is required as explained in 2).
2) Constant voltage battery charge mode
-Constant voltage equal to 14.40÷14.70V
-Initial charge voltage equal to 0.3÷0.5 for nominal capacity
-Duration of the charge: 10 to 12 h recommended
Minimum 6 h
Maximum 24 h
Electrical system
SMT RCR
ELE SYS - 44