Gilera SMT RCR 633793, Service Station Manual

Page: 25 / 118

- To adjust the mixer, operate on the correspond-
ing set screw shown in the figure.
- The correct oil flow rate is obtained by aligning
the two references shown in the figure.
Drive chain adjustment
It is convenient to check chain tension every 1000
km and, if required, adjust and lubricate the chain.
The chain is properly adjusted when, with the
scooter upright and without load, it looks as indi-
cated in the figure. Chain backlash should be be-
tween 30 and 45 mm.
To restore the proper chain tension, operate as
follows:
- Loosen the wheel pin nut.
- Operate on the set screws until the correct ten-
sion is obtained.
- Check alignment by means of the notches indi-
cated on the chain tightener inside the slot on the
fork, on both sides.
- Tighten the screws.
Locking torques (N*m)
Rear wheel axle
70-80
Set screw
17 ÷ 19
SMT RCR
Maintenance
MAIN - 25