Appendix A: Configuring/Activating FlexPay II CRIND
Page 22
MDE-5387D Hybrid Card Reader S (HCRS) Kit Installation Instructions · May 2020
10
Press
1
to activate the unit. The message, “ALL DISMOUNTING SENSORS ENABLED
UNIT ACTIVATED” is displayed.
Note: If the unit fails to activate, pressing Enter will exit this screen.
Figure 21: Activation Screen
11
When you receive the message “all sensors enabled”, the unit automatically goes back to the
main screen. From there, press
CANCEL
to restart the system. Perform one of the following:
• Press
OK
to exit the menu.
• Press
CANCEL
to restart the FlexPay II CRIND device.
Activation enables all the connected secure modules.
Note: It is not possible to enable only one component and retain the other components in an
inactive state.
Contrary to activation, the deactivation procedure does not require keypad entries. Therefore,
no options are available in the menu. When the system sensors detect that a module with
mounting sensors is dismounted, it automatically self-deactivates. The activation procedure
must be repeated.
At each power up, if the FlexPay II CRIND main processor detects a module that is not
activated, it will automatically enter the Service Menu (green screen).
