Appendix A: Configuring/Activating FlexPay II CRIND
Page 20
MDE-5387D Hybrid Card Reader S (HCRS) Kit Installation Instructions · May 2020
4
Press
3
>
Enter
to enter the System Configuration Menu. This menu is used to set the reader
type to HCR.
Figure 18: Service Menu - Main Menu
5
Press
1
>
Enter
to set Contact Card-Reader Select.
6
If Internet Protocol (IP) address changes are required, they must be changed using
CRIND diagnostics. Using the Service Menu to change IP addresses may result in
communication issues with the dispenser.
WARNING
CAUTION
Press
Enter
to select HCR2 and press
Enter
again to go back to the main Service Menu.
7
Press
2
>
Enter
to enter the Security Setup Menu. This menu is used to activate security
mounting sensors.
The FlexPay II CRIND software modules are not activated and system communications are
not possible until the unit’s mounting sensors are activated.
The menu displays the following:
• UNIT SERIAL NUMBER: PPN shown at start-up.
• UNIT CHALLENGE NUMBER: Variable code generated when the FlexPay II CRIND
device starts.
• ENTER MATCHING PASSWORD: Matching password is the answer to the challenge
number.
Note: The Gilbarco Call Center provides the MATCHING PASSWORD by a secure process
that uses the serial number and challenge number, and produces a unique matching
password. It must be entered within a time limit (one minute) of the challenge number
being displayed or the screen times out and reverts to the main Service Menu.
