Installing the HCRS Kit
Page 12
MDE-5387D Hybrid Card Reader S (HCRS) Kit Installation Instructions · May 2020
Figure 4: HCRS Card Reader Mounted
Card Reader Bracket
10-pin HCRS Interface
Cable (M12471A001)
Screws (4X)
Card Reader
10-pin Power/Data
Connector (J6)
Ground
Connector
7
Remove the protective foam block from the card reader connector.
8
). To connect the cables, proceed as follows:
a
Plug in connector JHCRS of the HCRS cable on the 10-pin connector J6 on the HCRS
(see
). Connect the 10-pin HCRS Interface Cable (M12471A001) to the 10-pin
power/data connector on the HCRS card reader.
Note: Orient the connector as shown in
b
Plug in connector P501 of the HCRS cable to connector P501 on the FlexPay Control Board
(FCB) as shown in
Figure 5: Connecting P501 on FCB
P501
Connector
c
Remove connector J411 of the FCB power cable from the P411 connector of the FCB and
connect to the P411A connector on the HCRS cable (as shown in
on
