GGM gastro SIRIO 500, Manual For Installation, Use And Maintenance

Page: 28 / 70

5. FUNCTIONING AND USE
SIRIO 500 BANCO - 500 - 600 28
Controls description:
1
main switch (disconnector) with two positions; 0 = OFF I = ON.
2 general START button (green); before pressing it, check that the motion
start and reversal device(s) ref. 5 and ref. 6 are in neutral position.
3 stop button; by pressing it, the machine stops and the electric power
supply to the motor is reset.
4
(“VAR” version only) graduated knob for continuous adjustment of the
working speed.
5 manual control device for motion start and reversal.
*
6
control pedal for motion start and reversal (except for the “B” version,
countertop).
*
7 display that shows the dough sheeting thickness.
8 lever to adjust the dough sheeting thickness; turning the handle
clockwise decreases the sheeting thickness, while turning it anticlockwise
increases the thickness. The value of the dough sheeting thickness is
shown on the display ref. 7 as the lever is moved from one notch to the
other.
To move the lever press and hold the plate under the handle; when the
plate is released the pin will tend, pushed by a spring, to fit into one of the
notches in the lower part of the sector gear ref. 10; this will allow the
handle to remain in a stable position during sheeting and keep the sheeting
thickness steady; if the handle is released in an intermediate position
between two adjacent notches in the sector gear ref. 10, the thrust exerted
by the dough against the upper roller could cause it to move, but at most
until the pin engages in the first notch it encounters.
9 block + knob to set the desired minimum sheeting thickness; it can be
moved by hand along the slot after loosening the knob; once you found the
final position, fasten it with the knob; in this way the block will act as a
mechanical stop for the handle.
10 sector gear with notches that allows the handle to remain in a stable
position during sheeting and to keep the sheeting thickness steady.
*
The belts move towards the side where the joy stick is moved or the
pedal ref. 6 is depressed; by bringing the joy stick or the pedal to the
neutral central position the machine will not start when START button ref. 2
is pressed or, if it was in motion, it will stop.