GGM gastro SIRIO 500, Manual For Installation, Use And Maintenance

Page: 22 / 70

4. INSTALLATION
SIRIO 500 BANCO - 500 - 600 22
4.9. Electrical Connection
The equipment is supplied with electrical connection cable with an
earth wire. In compliance with the norms in force. It is obligatory to
connect the ground/earth cable (yellow-green) to an earthing system
with the same dispersion capacity as the appliance itself. The
efficiency of this system must be correctly verified according to the
norms in force.
Before making any connection, check that the specifications of the
electrical supply to which the equipment must be connected, correspond to
the specifications of the power supply required by the apparatus itself (see
Enclosure A).
See Enclosure B for the exact cable output position for the equipment
supply.
The electrical socket must be easily accessible and must not require
further location after the installation of the equipment. The distance
between the equipment and the socket must be sufficient to avoid
stretching the power cable. The power cable must never be trapped under
the feet or wheels of the equipment.
For machines with three-phase power supply, when starting up for the
first time check the direction of rotation of the motor: the movement of the
belts must be consistent with the start and reverse control device as
described in par. 5.2.1, ref. 5 and 6; if this is not the case, switch two
phase conductors (
take care not to switch a phase conductor with the
earth conductor ; the latter can be identified by its yellow-green colour).
If the Power cable is damaged it must be substituted by
customer support or by a qualified service engineer so as to avoid
any risk.
The Manufacturer does not accept responsibility for damage
caused by failure to observe the abovementioned norms.