gfm GF-Primo Dolly, Instruction Manual And Safety Manuallines

Page: 49 / 92

48
Wireless signal (RF POWER)
RF POWER or signal strength can be adjusted from range 1 (normal distance or mild signal strength)
up to step 4 (for longer distance or strong signal strength). We recommend step 1 or 2.
To adjust or set the RF Power proceed as follows:
Using the Rocker Switch, select the sub-menu point RF Power and confirm by pressing
ENTER.
Use the Rocker Switch to increase or decrease the range within 1 to 4.
Return to NORMAL mode by pressing the ENTER button and backtracking through the
menus.
11.1.1.4 Sub-menu point JIB ON / JIB OFF
The JIB ON / JIB OFF mode enables the selection of a special jib-arm mode, specifically for use with
the GF-Primo Jib. JIB ON must be selected when using the GF-Primo Jib. By doing so, a range of
preselected speeds and ramps will be activated to ensure a safe jib arm operation. The maximum
speed is reduced to speed 9 whereby the ramp range is restricted to begin at ramp 14. The JIB ON
mode will be indicated by a flashing
„JIB ON“ and dolly with jib-arm symbol on the HCU display. To
leave JIB ON mode, select JIB OFF in the menu and confirm by pressing ENTER.