GEZE Powerturn, Installation And Service Instructions Manual

Page: 49 / 56

Powerturn
49
Supplementary installation sheet for fitting the lever in the correct position
No. Test on Page in Chapter Completed
13 Closing force set?
à
Set closing force, see supplementary instal-
lation sheet, chapter 12
à
The closing time for the de-energised
state must be set using the braking force
parameter.
230 V is required at the drive for this
(see chapter 9.2).
41 9.1
14 Latching action adjusted? 43 9.2
15 End caps cut out and drilled?
Sensor strips installed?
44 9.3.1
16 Peripheral cables connected? 29 7.7
17 End caps inserted?
Option: The side panel at the control unit can
also be installed after the cover.
44 9.3.2
18 E-cover fitted onto the connection panel?
All cables secured?
45 9.3.2
19 Additional cable guide set in place? 30 7.8
20 Cover attached? 46 9.3.3
21 Powerturn put into operation with ST220 (jack plug on the side panel)?
(See wiring diagram)
X
Set the opening time to “Limitation of use of Pow-
erturn with opening times up to 90° door opening
angle” in accordance with chart Page 8.
For fire protection doors:
X
Set the door stop buffer.
– –
12 Supplementary installation sheet for fitting the lever in the correct position
For assistance, the closing torques to be set are listed on the supplementary installation at the end of the installa-
tion instructions.
Use the supplementary installation sheets as follows:
X
Cut the supplementary sheets along the grey dashed line and taken them out of the manual.
X
Cut out the openings for the lever mandrel along the black dashed line.
X
Place the supplementary installation sheet on the lever mandrel on the drive in accordance with the type
of installation.
The correct insertion position of the lever can now be checked.