Geolux LX-80-15, User Manual

Page: 47 / 62

LX-80-15 10 Hz User Manual
43 LX-80-15 10 Hz Oceanographic Radar Sensor
Name Command Response Details
Get IIR filter
constant
aXGLIR! a+c<CR><LF> +c – IIR filter constant used in IIR
filter
Set IIR filter
constant
c! a+c<CR><LF> +c – IIR filter constant used in IIR
filter, recommended range is from
+0.0 to +1.0
Get peak detector
type
aXGPDT! a+t<CR><LF> +t – identifies the peak detector
type, can be any of the following:
0 – report the distance to the max-
imum peak which corresponds
to the maximum radar signal
reflection
1 - report the last peak which cor-
responds to the furthest reflection
from the radar; this may include
multipath reflections in typical
cases and should be avoided
Set peak detector
type
t! a+t<CR><LF> +t – identifies the peak detector
type, can be any of the following:
0 – report the distance to
the maximum peak which
corresponds to the maximum
radar signal reflection
1 - report the last peak which
corresponds to the furthest
reflection from the radar; this
may include multipath reflections
in typical cases and should be
avoided
Get wave analysis
length
aXGWAL! a+f<CR><LF> +f – the wave analysis length, in
range between 0 and 3600
Set wave analysis
length
f! a+f<CR><LF> +f – the wave analysis length, in
range between 0 and 3600
Get NMEA protocol
flags value
aXGNPF! a+d<CR><LF> +d – NMEA protocol flag value
0 – all sentences are sent
1 – $WAV is not sent
2 – $ANG is not sent
3 – $WAV and $ANG are not
sent
Set NMEA protocol
flags value
d! a+d<CR><LF> +d – NMEA protocol flag value
0 – all sentences are sent
1 – $WAV is not sent
2 – $ANG is not sent
3 – $WAV and $ANG are not
sent