Genius VividPro II, User Manual, Page: 11 / 91

Chapter I. Hardware Installation
4
Attention: If you do not have a printer
connected to your computer or you are not sure
where the parallel (printer) port is, see your
computers information book and locate the
section referring to the parallel port, printer
port or LPT1 (all refer to the same thing).
8. After plugging the scanner and printer
cables into the correct locations, plug the
power adapter into the scanners power
receptor (see Figure 1, step 3).
9. Plug the other end of the power adapter
into a standard AC outlet.
Attention: To conserve energy, the scanners
light source will not turn on until it is initialized
after the software installation .
10. Plug in all power cords and turn on your
computer.
11. Install the scanner software (see Chapter
II. Software Setup ).
Installing the Transparency
Adapter*
(*This section applies to select models only that have a
transparency adapter.)
The transparency adapter is located on the
underside of the scanner lid and is a necessary tool
when scanning positive or negative film.
The transparency adapter already comes installed
in your scanner model. To activate it, simply plug it in
as shown in Figure 2 below.
Attention
Attention