Part No. 52709
Genie Z-45/25 & Genie Z-45/25J
7 - 43
First Edition • Second Printing
Section 7 • Repair Procedures
8-1
RPM Adjustment
Refer to Maintenance Procedures, A-22,
Check and Adjust the Engine RPM.
8-2
Flex Plate
The flex plate acts as a coupler between the
engine and the pump. It is bolted to the engine
flywheel and has a splined center to drive
the pump.
a
pump
b
pump shaft
c
coupler
d
flex plate with raised spline
e
flywheel
f
1
/
16
inch (1.5 mm) gap
How to Remove the Flex Plate
1 Disconnect the wiring plug at the electronic
displacement controller (EDC), located on
the drive pump.
2 Support the drive pump with an appropriate
lifting device. Then remove all of the pump
mounting plate to engine bell housing bolts.
3 Carefully pull the pump away from the engine
and secure it from moving.
4 Remove the flex plate mounting fasteners,
then remove the flex plate from the engine
flywheel.
How to Install the Flex Plate
1 Install the flex plate onto the engine flywheel
with the raised spline towards the pump.
Torque the flex plate mounting bolts to 34 ft-lbs
(46 Nm).
2 Install the pump coupler onto the pump shaft
with the set screw toward the pump. Leave a
1
/
16
inch (1.5 mm) gap between the pump
coupler and pump end plate.
3 Apply Loctite
®
removable thread sealant to the
pump coupler set screw. Torque the set screw
to 45 ft-lbs (61 Nm).
4 Install the pump and torque the pump mounting
plate fasteners to 34 ft-lbs (46 Nm).
Component damage hazard. Do
not force the drive pump during
installation or the flex plate teeth
may become damaged.
a
b
c
d
e
f
Perkins 104-22 Engine
Summary of Contents for Z-45 XC
