7 - 82
Genie Z-45/25 & Genie Z-45/25J
Part No. 52709
First Edition • Second Printing
Section 7 • Repair Procedures
2 Loosen the wheel lug nuts. Do not remove
them.
3 Block the non-steering wheels, and then
center a lifting jack of ample capacity under the
steering axle.
4 Raise the machine 6 inches (15 cm) and place
blocks under the chassis for support.
5 Remove the lug nuts. Then remove the tire
and wheel assembly.
6 Remove the pin retaining fasteners from the
yoke pivot pins. Do not remove the pins.
7 Support and secure the yoke/hub assembly to a
lifting jack.
2WD Steering Axle Components
15-1
Yoke and Hub
How to Remove the Yoke
and Hub
The yoke installation utilizes bushings in the axle
and a thrust washer that may require periodic
replacement.
1 Remove the cotter pin from the steering cylinder
rod-end clevis pin and remove the cotter pin
from the tie rod clevis pin. Remove the clevis
pins.
Always use a new cotter pin when
installing a clevis pin.
a
tie rod
b
steer axle
c
yoke pivot pin
d
yoke
e
hub
f
pivot pin
g
steering cylinder
a
b
e
d
f
g
c
f
Summary of Contents for Z-45 XC
