Genie Z-45 XC, Service Manual

Page: 101 / 440

Part No. 52709 Genie Z-45/25 & Genie Z-45/25J 4 - 71
First Edition • Second Printing Section 4 • Scheduled Maintenance Procedures
9 Disconnect and plug the supply hose for the
auxiliary power unit through the access hole
underneath the turntable. Cap the fitting on the
hydraulic tank.
10 Remove the ground controls side turntable
cover. See Repair Procedure 6-1, How to
Remove a Turntable Cover.
11 Support the hydraulic tank with an appropriate
lifting device.
12 Remove the hydraulic tank mounting fasteners.
13 Remove the hydraulic tank from the machine.
Crushing hazard. The hydraulic
tank may become unbalanced and
fall if it is not properly supported
by the lifting device.
14 Remove the suction strainers from the tank and
clean them using a mild solvent.
15 Rinse out the inside of the tank using a mild
solvent.
16 Install the suction strainers using a thread
sealant on the threads.
17 Install the drain plug using a thread sealant on
the threads.
TABLE E PROCEDURES
18 Install the hydraulic tank onto the machine.
19 Install the two suction hoses to the suction
strainers.
20 Install the supply hose for the auxiliary power
unit and the return filter hose.
21 Fill the tank with hydraulic oil until the level is
within the top 2 inches (5 cm) of the sight
gauge. Do not overfill.
22 Clean up any oil that may have spilled and open
the hydraulic tank valves.