Genie GS-2669 IC, Service And Repair Manual

Page: 93 / 171

May 2022 Service and Repair Manual
Manifolds
Part No. 1306516GT GS ™ -2669 RT • GS ™ -3369 RT • GS ™ -4069 RT 79
How to Test the C oils Using the Tes t Syste m F unctio n How to Test the Coils Using the
Test System Function
The Electronic Control Module (ECM) contains
programming that can test the coils on the function
and traction manifolds. If a fault is detected it will
show in the diagnostic display window.
Note: Perform this procedure on a firm, level
surface with the machine in the stowed position.
1 Pull out the red Emergency stop button to the
on position at the platform controls.
2 Push in the ground controls red Emergency
Stop button to the off position.
3 Turn the key switch to ground controls.
4 Press and hold both the blue platform up and
yellow platform down buttons. Pull out the red
Emergency Stop button to the on position at
the ground controls.
Result: TUNE SPEEDS is showing in the
diagnostic display window.
1 diagnostic display
2 blue platform up button
3 lift function enable button
4 yellow platform down button
5 Use the yellow platform down arrow to scroll
to test system.
Result: TEST SYSTEM is showing in the
diagnostic display window.
6 Press the lift function enable button.
Result: RUN SYSTEM TEST is showing in the
diagnostic display window.
7 Press the lift function enable button.
Result: NO FAULTS DETECTED is showing
in the diagnostic display window.
Result: A fault is detected and showing in the
diagnostic display window.Refer to Fault
Codes Section.
8 Push in the ground controls red Emergency
Stop button to the off position.